3G WiFi Mobile DVR

Product Detail

PARAMETERS

HDD Fixed Screw	Please manually tighten screw after installing hard disk drive, to prevent HDD slip out ;
GPS	GPS/BD Status indicator light.
NET	Network Indicator LED. It changes based on dial-up connection status
ALMARM	Alarm Indicator LED. LED ON — In the alarm
SD CARD	SD card Indicator LED. LED ON—Card is recording,LED FLASH—Card exists but not recording,LED OFF—Card does not exist.
16 PIN Extension Port	With Video&Audio output interface?alarm input&output? serial port etc.
Rj45 Ethernet port	with print serial port, Can only connect 4PIN net cable
Power Input interface	Input Voltage DC 8-36V
Black	cable connect power cathode




Attention : The device will automatically format the hard disk/SD card to pre-allocate the storage space before starting to record video, please use a professional hard disk/SD card to test !






Before installing and using please read the following warning carefully.

Ø The recorder uses DC power supply, input DC range is 8V-36V, Please pay attention to VDD and GND when connecting the power, DO NOT make DVR short-circuit.

Ø After DVR connect camera, the initial power must be over 30W (Specific power consumption will vary depending on the external equipment),Power Supply must be provided over 30W.



Ø From the power supply to DVR all power cables must ensure that the diameter is thick enough to withstand more than 60Watts. For example, when the vehicle power supply output voltage is 12V , the source line must be able to withstand 5Amps or more;

Ø Install the equipment in the dry environment, avoid damp, drip, water spray,etc.

Ø To extend the life of the equipment, please install the equipment in the weak vibration part of the vehicle;

Ø The equipment should be installed in the vehicle interior ventilation, do not install in the closeness environment;



Ø Ensure that equipment away from the heat source in the vehicle, the equipment can not have sundries piled up;

Ø As far as possible from the electromagnetic environment, away from the strong interference environment;

Ø Ensure that passengers or drivers can not interfere and damage any component of the equipment.

Ø The installation and all materials must bear the fuselage weight.

Ø It is recommended that the power cord wear heat resistance, waterproof and oil proof casing which can prevent the short circuit or break up due to the long time vibration in the vehicle.;

Ø In the absence of professional guidance, please do not open or remove the equipment.